192.168.1.0 Admin Login Router
192.168.1.0 is C class 24 Subnet Network ID for IP series 192.168.1.1 to 192.168.1.254. Although 192.168.1.0.1 is a network Id that not used for a login IP address but some router brands like 2wire and other use a network id series to configure all IP address range automatically. If you have a router that pre-configured with the default gateway IP address 1922.214.171.124 and looking a login user manual to access the web interface then follow this user manual. You need a login username and password along with IP address to access router settings from the web interface to manage anything.
There is two ways to access your router login page using 192.168.1.0 using the wireless or wired connection. If your router or DSL modem support wireless and Ethernet both option than you can connect using wired or wifi. If your router or cable modem does not supports wireless then you have to connect to PC/Laptop using a LAN port to access the web interface.
Default Login username and password
The first thing is to find a login username and password for your modem and router that work 100% as pre-configured in default mode. If you lost your login credential and not sure about your router model and login settings then you can try the given password and username combination below that works with most of the leading brands.
The next step is a physical or wireless connection with the router to access the web interface from a browser or mobile device.
Steps to Access Router with 192.168.1.0
The most important part is the connection with the router either wireless or wired connection to access the web interface. Every router, cable modem provider one or multiple Ethernet ports to connect to the internet to a wired device. if your modem or router also supports wifi then you can also connect using wifi name and SSID.
- Power on your cable modem or router using a DC adapter comes with a box.
- Use LAN cable to connect the wired cable from Ethernet port to PC LAN port or use wireless SSID or password to connect from WiFI.
- Go to PC/laptop LAN settings and use DHCP to get an IP address from the router DHCP server.
Access Router web interface
Open a Web browser and access http://192.168.1.0 and wait to load the login page.
Provide username and password as printed to router/modem sticker and authenticate to access router control panel.
Once you logged into router settings you get full access to all settings where you can configure WAN internet settings as supported your internet connection, update wireless SSID name and password as well as enable parental control, enable MAC access list to allow or deny the user to prevent un-authorize access in-network.
Apart from accessing the router IP address if you are getting any login issues while accessing the 192.168.1.0.0 IP address to login router settings you need to troubleshooting the network and any other issues. If you forget login password, IP address not working or taking a too long time to respond as well as getting error site can’t reach then make router to factory reset to fix all issue and start from starting.
Factory Reset Router to Restore IP address 192.168.1.0
Making router default will restore into factory mode and all configuration and settings will remove and required to restore configuration backup or manually configure to work router with your internet connection again.
User Guide to Reset Router
- Find a small reset switch in the router’s backside or bottom side.
- Press the reset button using a needle or paper clip for 5-10 seconds
- Release the reset button when the router led turns off and turns it on again quickly.
- The router will automatically reboot and take 1-2 minutes to restore settings into factory mode.
Follow the above steps from starting to set up the router again with router IP 192.168.1..1 or 192.168.1.0.0 depend on router default settings.
- 10.1.10.1 Admin login Username and Password
- 192.168.100.100 Login Username and Password
- 192.168.0.254 Login Admin Password
- 192.168.8.1 Login Admin Username and Password